codynewman13 Posted September 4, 2011 Report Share Posted September 4, 2011 i just rebuilt my banshee and when i took it for a spin when i went to down shift my lever went limp i can pull my lever and it moves the arm but there is no pressure between them what should i do? Quote Link to comment Share on other sites More sharing options...
locogato11283 Posted September 4, 2011 Report Share Posted September 4, 2011 It sounds like the shift shaft is not sitting on the shift star properly. What kind of a rebuild did you do? Quote Link to comment Share on other sites More sharing options...
sinisterboo Posted September 4, 2011 Report Share Posted September 4, 2011 (edited) detent spring on the roller for the shift star>? Edited September 4, 2011 by sinisterboo Quote Link to comment Share on other sites More sharing options...
Phelps Posted September 4, 2011 Report Share Posted September 4, 2011 clutch arm, or shifter? take the clutch cover off and start looking. Quote Link to comment Share on other sites More sharing options...
locogato11283 Posted September 4, 2011 Report Share Posted September 4, 2011 So you're talking about the clutch lever and not the shift lever huh? Your first post is a little confusing. Quote Link to comment Share on other sites More sharing options...
codynewman13 Posted September 5, 2011 Author Report Share Posted September 5, 2011 i was talking about the actual clutch arm that sits on the top of your cases that your clutch lever pulls in, but anyways i figured out the problem i forgot to tighten the bolt that holds that little push pin in the center of your clutch basket but its all fixed now Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.