252wheelieking Posted September 3, 2011 Report Share Posted September 3, 2011 (edited) I brought a chrome swingarm from unbroken526 that was suppose to be a +5 for the banshee. I recieve it like a week or two later & it been under my bed until today. I finally got my extended brakelines & 120 link chain, so I went to install it today & it had left to right play in the front of the swinger where you mount it to the frame. So I looked carefully & it a little narrow than the stock swinger. Then I decided to see if the stock banshee axle carrier would fit & it didn't. Then the stock carrier is to small to fit in between the rear bracket where you install the bearing carrier. The only two ATV that im familiar with that this carrier might fit are the blaster & warrior. Can you guys help me out with what this carrier was built for. Here is a pic of it. Edited September 3, 2011 by 252wheelieking Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted September 3, 2011 Report Share Posted September 3, 2011 Not a Blasturd, pivot is two pieces Quote Link to comment Share on other sites More sharing options...
252wheelieking Posted September 4, 2011 Author Report Share Posted September 4, 2011 (edited) I looked this swinger over again & compared it to my stocker. The holes at the top where the bearing carrier mounts on the stocker has washers in between them & the chrome one does not. The front of the chrome swinger where the dust caps go are loose when the stocker dust caps & seals are installed. HELP Edited September 4, 2011 by 252wheelieking Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.