greg_banshee Posted June 30, 2011 Report Share Posted June 30, 2011 Hey i'm trying to jet my TM-34mm Mikuni flat slide carbs and it just doesn't seem to be working out for me... i'm getting frustrated. What would be a good starting point for me with these carbs? (Mains, pilots, air screws, needles) Mods are: Dune/Play port job (stock cylinders) 66mm Bore case matched pistons are window matched 4mm Stroker 5mm Long Rod Chariot Billet intakes VF3 reeds Pro Circuit exhaust +4 timing Uni Pod filters Elevation is at sea level any help would be great thanks. Quote Link to comment Share on other sites More sharing options...
camatv Posted July 1, 2011 Report Share Posted July 1, 2011 seriously call SUDCO and see if they have a suggestion for the needle and mains. you should know the slide cut out also and let them know that. the slide cut should be a number on the bottom of the slide. without needles that are close yoru going to be pulling your hair out on them. also if the cut out is to far off it will off idle like hell. might also want to jot down the fuel needle and seat size. make sure yoru not trying to run pumper needle adn seats on a gavity fed bike/. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.