calcium12 Posted June 27, 2011 Report Share Posted June 27, 2011 How do you replace the seal/gasket thingy that the shitfer rod goes through Quote Link to comment Share on other sites More sharing options...
Starwriter Posted June 27, 2011 Report Share Posted June 27, 2011 Take something small and sharp. I have a small screwdriver like the size for adjusting carburetor air screws, ground to a point. Pound it into the seal kinda sideways, kinda close to the outside edge, but not right at the edge. Pound in a direction so that your not going towards the shaft or towards the bored part of the cases. Then put a wrench or something under it for a pivot point, and then pry it out. It's really not that hard. Just be careful not to damage the shaft or the cases. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.