SheezFast02 Posted May 14, 2011 Report Share Posted May 14, 2011 Hey guys, so I got my Banshee running pretty good after starting my jetting out really rich. I still feel like the bottom end could be better, though. I'm down to 45 pilots and 148 mains and it's pulling hard through the powerband. I pulled my plugs yesterday and they seem to be a good colour (tan) and both plugs look the same, but they're still a little wet. Does anyone think I could drop one more size on my pilots and mains, or could the issue be something else? This bike starts first kick, and doesn't foul plugs. The plugs are just a little wet after a ride and they clean right up with a rag. Would really appreciate some help with this. Mods: -PWK 28's -"NAPE" needle on middle groove -UNI dual stage foam filter -No lid -FMF Fattys w/ PC2 -Boyesen Rad Valves - 300' Above sea level -45 Pilots -148 Mains Quote Link to comment Share on other sites More sharing options...
SheezFast02 Posted May 16, 2011 Author Report Share Posted May 16, 2011 Wow, don't everybody help at once lol.. I'll get it figured out. Quote Link to comment Share on other sites More sharing options...
Zwiser Posted May 16, 2011 Report Share Posted May 16, 2011 what ratio are you pre mixing? Quote Link to comment Share on other sites More sharing options...
sleeper06 Posted May 18, 2011 Report Share Posted May 18, 2011 as soon as you idle for a couple of seconds your plugs get wet,its kind of an open answer,Its seemed from previus posting that those caerbns run small jets,Have you done a plug chop yet to see if your main is dialed in.For bootom either play with your needle hieght or drop the pilot,you wont hurt it fropm dropping the pilot Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.