2004shee Posted May 3, 2011 Report Share Posted May 3, 2011 (edited) I live in the Omaha, Nebraska area and am wanting to get my cylinders bored and then i will rebuild with a wiseco topend kit... were in this area is a good shop and good price to get it done... thanks and whats a good size to go from stock? Edited May 3, 2011 by 2004shee Quote Link to comment Share on other sites More sharing options...
okbeast Posted May 3, 2011 Report Share Posted May 3, 2011 I'm not sure of a shop in that area, but only go as big as you have to. Have them figure out what size it needs, then buy pistons, then have them bore to that size. Quote Link to comment Share on other sites More sharing options...
BigRed350x Posted May 3, 2011 Report Share Posted May 3, 2011 Pack em up and send them off to Kevin at Herr Jugs Racing. He will hook you up. You only want to bore them enough to clean them up. Don't eat up bores trying to make power. If you want power, you need to get the ported. Kevin can do that for ya too. Send them to him and he will get you the top end you need and do the bore/hone and send them back to ya ready to install and run. - Jared Quote Link to comment Share on other sites More sharing options...
jbooker82 Posted May 3, 2011 Report Share Posted May 3, 2011 Jeff at FAST is 130 miles straight south of you in Holton, KS. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.