amont21987 Posted March 21, 2011 Report Share Posted March 21, 2011 I took my carbs off and it is running like shit and smoking and I need to figure out how to set the float height please help Quote Link to comment Share on other sites More sharing options...
Surfrjag Posted March 21, 2011 Report Share Posted March 21, 2011 you dont need the tool but the info is ok.. i just googled it for you. http://www.factorypro.com/tech_tuning_procedures/tuning_float_height_adj_procedure.html Quote Link to comment Share on other sites More sharing options...
700vflash Posted March 21, 2011 Report Share Posted March 21, 2011 Get a shop manual, it will give you pictures and step by step on how to adjust. That is were you need to get your info!! Quote Link to comment Share on other sites More sharing options...
VooDooBanshee Posted March 21, 2011 Report Share Posted March 21, 2011 I bet you put your slide in backwards.... Quote Link to comment Share on other sites More sharing options...
amont21987 Posted March 22, 2011 Author Report Share Posted March 22, 2011 If your slide is the circle thing that comes out when you screw the top of the carb off I couldn't have put it in backwards because it had a slot in it and their is a little thing in the carb on the wall that it slides down into so you can't put it in backwards but that is the only thing that I took out and I didn't adjust anything else just sprayed the entire thing down with carb cleaner Quote Link to comment Share on other sites More sharing options...
Banshee Chad Posted March 23, 2011 Report Share Posted March 23, 2011 How much cleaner u spray in there? Enough to fill the bowls? Quote Link to comment Share on other sites More sharing options...
amont21987 Posted March 23, 2011 Author Report Share Posted March 23, 2011 No but I did soak my whole carbs in gas to get all the crud off the outsides before I cleaned the insides. What do I do if the floats are full of gas Quote Link to comment Share on other sites More sharing options...
700vflash Posted March 23, 2011 Report Share Posted March 23, 2011 If the float is full of gas then it has a hole in it and needs to be replaced. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.