jbones Posted February 7, 2011 Report Share Posted February 7, 2011 I pulled my motor and split the cases to change a tranny bearing an found the stator side rod looking like it got very hot any ideas y ? Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted February 7, 2011 Report Share Posted February 7, 2011 post a pic of both rods Quote Link to comment Share on other sites More sharing options...
Wicked ATV Posted February 7, 2011 Report Share Posted February 7, 2011 I pulled my motor and split the cases to change a tranny bearing an found the stator side rod looking like it got very hot any ideas y ? Lack of oil but also possible the rod bearing getting ready to go. So you probably got the issue right before actual damage got bad. It's time to rebuild or new crank at this stage. No saving it unless you wanted to just risk it. Quote Link to comment Share on other sites More sharing options...
camatv Posted February 7, 2011 Report Share Posted February 7, 2011 dang everyone has those cranks!! Quote Link to comment Share on other sites More sharing options...
Wicked ATV Posted February 7, 2011 Report Share Posted February 7, 2011 dang everyone has those cranks!! lol....... na nah.... CAMATV The difference is we assemble all our cranks here in house assembled in the "USA". They are not ship from over seas like everyone elses. We seen how many crank failures happen out there off the China and Taiwan ones and just laughed.... We'd hate to put our name on something like that and end up paying for problem that should off been prevented if we did our own build instead. We been building cranks for +12 years already. We use better quality Bearings and better lower rod cage bearings. We've Been building +4mm to hold 120-130HP on NOS and no problems yet do to crank failure. A lot better quality built VS the Run of the Mill e-bay stuff you see. + we guarantee our cranks to be on point when you get them. The pic you see is right before the last phase of assembly. We can assemble these cranks with what ever rods or specs you like them to be. You name we do it here in house We have a base crank price and go from there. Our Top $$$ +4mm runs $599.99. If you like to just purchase the wheels we can do that too and you can build your own. If interested feel free to drop us a message and we'd be happy to help you out with one too. Quote Link to comment Share on other sites More sharing options...
jbooker82 Posted February 8, 2011 Report Share Posted February 8, 2011 Does it actually look like it got hot or is it just blueing on the webs from when they heat it up to press the crank together? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.