VF3 vs VF2

[Loc]

I have a set of each and deciding between running the 2 or the 3. I searched and did not find what I am looking for. I want opinions from people who are running the reeds. I am going to be running them on a 421 Cub and would like to know what reed setup to run. Thanks

[mercury65]

well IMO the v2 is junk they use screews in them and how well will screews hold in plastic, not well cost me a topend fell apart and pow

i run the chariots with the 2 stage boysen and i love them

i did call them and the guy said he would repair them free and i said if they fall apart agen you going to replace what they break and he said "nope" and i said "then you can take them and shove them up your ass"

[mailman]

The vforce 2's will flow more air than the 3's. Whether or not your motor will support that extra flow will determine if you will see a hp gain with v2's. I agree on the reliability issue of the v2's and I personally have taken a few motors apart where the screws were either loose or had just fallen out of the 2's.

What is the goal? If you say HP and drag only then I would say run the v2's and locktite the screws. If you ride dunes, trails, etc. and want reliability then the v3's are for you. I personally run the v3's because of reliability. I am too old to be breaking down.

 

I hope that helps,

 

 

Mailman

[firebanshee]

I like the 2s with locktight.

[jbooker82]

I though locktight ruined plastic.

 

 

I would run v force 3's with cascades reed stuffers / retainers.

http://67.199.65.66/cascade_innovations/newlook/store/store_View.cfm?STORE_AREA_ID=13&store_dept_id=83