bansheebandit1990 Posted June 10, 2010 Report Share Posted June 10, 2010 i have a 95 banshee..i just put new pistons in it and also the oil seals. and now it is only running on one cylinder. and both cylinders are getting spark and fuel. wat could it be? Quote Link to comment Share on other sites More sharing options...
toytech Posted June 10, 2010 Report Share Posted June 10, 2010 (edited) i have a 95 banshee..i just put new pistons in it and also the oil seals. and now it is only running on one cylinder. and both cylinders are getting spark and fuel. wat could it be? welcome to BHQ switch your plugs and see if it changes to the other cyl. and clean the carbs Edited June 10, 2010 by toytech Quote Link to comment Share on other sites More sharing options...
J-Madd Posted June 10, 2010 Report Share Posted June 10, 2010 Synchronize the carbs (adjust cable to they open and close at the same time) and make sure the throttle cable is not in a bind anywhere. Make sure the choke tube is in place. Black hose that connects the carbs together. Quote Link to comment Share on other sites More sharing options...
pr0blumz Posted June 10, 2010 Report Share Posted June 10, 2010 I would advise you to perform a leak down test as well, if you haven't already. Quote Link to comment Share on other sites More sharing options...
MatHolland Posted June 10, 2010 Report Share Posted June 10, 2010 welcome to my nightmare...im in the same situation...was running fine before the rebuild except psi difference..rebuilt it and did a few other mods and slapped it back together and it doesnt run right....right plug is super lean....ive tried everything...so im finally doing a leak down...i just buiilt my tester..i recommend you to do that. if you have an air leak then you will run super lean. Quote Link to comment Share on other sites More sharing options...
SAVAGE420 Posted June 10, 2010 Report Share Posted June 10, 2010 welcome to my nightmare...im in the same situation...was running fine before the rebuild except psi difference..rebuilt it and did a few other mods and slapped it back together and it doesnt run right....right plug is super lean....ive tried everything...so im finally doing a leak down...i just buiilt my tester..i recommend you to do that. if you have an air leak then you will run super lean. Quote Link to comment Share on other sites More sharing options...
fastquad02blaster Posted June 11, 2010 Report Share Posted June 11, 2010 Does it not hit all through the rpm range? I had it happen just off an idle and carbs were out of sink but the other one would kick in and run like it was supposed to. I guess if they are out of sink bad enough it could be that. I think that it's a vacuum leak. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.