namura piston rings?

[hollisatp]

I need to get a new set of oem rings for a cr250.. i found this brand on ebay... any info on how they are?? better than oem? worse?

thanks!

[Crazyatvspazz]

1st- numaura IS NOT OEM 2nd- Numara sucks from ive read...get weisco 3rd- id recommend getting a new piston AND rings ...you already have it torn down...take your cylinder to a shop get a weisco piston kit and have them bore it over.... and make sure you get all new gaskets...my .02

[scottzimmerman]

i just put a set in my shee Ive had good luck with them in the past i put a set in my 99 kx 250 and they lasted for 5 years and they were hard years i put on it we will see how they work on the shee I'm hoping for the same results i only got about 2 hours on them in the shee the only reason i went with them is because my cylinders were still at stock bore and pistons were still good so i gust through a hone job on them and ringed it other wise i would have went weisco so Weill see if they fail and fuk my shit up ill get my 4mm set up wooo hooo that's my .02

[drag+6blaster]

there ok pistons .. If your piston-wall clearance is good they will hold up

[jbooker82]

You should always run the same brand of rings on the same brand of piston. If you need a ring for an OEM Piston then order it from honda. Pistons can be made up of different alloys and require different piston rings.