slopoke Posted August 16, 2009 Report Share Posted August 16, 2009 Do the 795 series pistons and the blaster pistons have the same pin height? Quote Link to comment Share on other sites More sharing options...
XxMeltIcexX Posted August 16, 2009 Report Share Posted August 16, 2009 Yes, but 795 series have a banshee dome profile. If i'm not mistaken the pin on the blaster pistons even have a little offset towards the front of the piston Quote Link to comment Share on other sites More sharing options...
slopoke Posted August 16, 2009 Author Report Share Posted August 16, 2009 Well what is the largest 795 that is offered? Is the blaster dome smaller? Quote Link to comment Share on other sites More sharing options...
bansheeseat$$ Posted August 16, 2009 Report Share Posted August 16, 2009 The banshee dome has a 13 degree angle and the blaster has a 9 degree angle Quote Link to comment Share on other sites More sharing options...
jbooker82 Posted August 16, 2009 Report Share Posted August 16, 2009 Blaster pistons are shorter from the wrist pin to the top of the piston head too. I think 795s end at 66.00 or 66.50mm. Quote Link to comment Share on other sites More sharing options...
slopoke Posted August 16, 2009 Author Report Share Posted August 16, 2009 Thanks all. My problem is that I have a set of 66 over cylinders that need a clean up. I was wondering if the blaster piston would work to get one more bore. They have a good port job that I would like to use once more. ANY SUGESTIONS???? Sleeving doesn't seem cost affective Quote Link to comment Share on other sites More sharing options...
TurboBanshee420 Posted August 17, 2009 Report Share Posted August 17, 2009 wiseco makes 68mm banshee pistons... buy a cub if you want that big of a bore. i just got one...they are sweeet!! Quote Link to comment Share on other sites More sharing options...
slopoke Posted August 17, 2009 Author Report Share Posted August 17, 2009 wiseco makes 68mm banshee pistons... buy a cub if you want that big of a bore. i just got one...they are sweeet!! I don't think the 795 series goes that high. I just need to get 1 more use out of these clylinders. I do not want cubs. I need to stay with stock appearing. It's not a matter I want it that big I just am at 66 right now. I didn't think the 795's went over 66. Quote Link to comment Share on other sites More sharing options...
slopoke Posted August 17, 2009 Author Report Share Posted August 17, 2009 Will a blaster piston work just to get me by for a 66.5 bore? This is on a 4mill long rod Quote Link to comment Share on other sites More sharing options...
jbooker82 Posted August 17, 2009 Report Share Posted August 17, 2009 Yea it will work. You will just need a new set of domes. Call noss and tell him what your running he will be albe to hook you up. Tell him your running a 4 mill long rod stock cylinder running blaster pistons. If you tried to run them with banshee stroker domes you would be down on compression and have a huge squish clearance. I had a pair of drag ported 4 mill cylinders resleeved with big bore sleeves. I just ran blaster pistons. They were 66mm through 68mm. Noss cut me the domes. josh Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.