joee20002 Posted August 2, 2009 Report Share Posted August 2, 2009 so how much adjustability is there in a power jet? like if my main is a .118 and i closed the power jet all the way what size would it be then? Quote Link to comment Share on other sites More sharing options...
joee20002 Posted August 3, 2009 Author Report Share Posted August 3, 2009 anyone???????? Quote Link to comment Share on other sites More sharing options...
XxMeltIcexX Posted August 3, 2009 Report Share Posted August 3, 2009 Depends what kind of PJ it is. Quote Link to comment Share on other sites More sharing options...
shanYE west Posted August 3, 2009 Report Share Posted August 3, 2009 The size of the main jet has no bearing on size the power jet is. In a variable clipard jet.. The power jet can be adjusted from closed to full open wich is limited to the ID size of the power jet. Quote Link to comment Share on other sites More sharing options...
joee20002 Posted August 4, 2009 Author Report Share Posted August 4, 2009 there from rdz..... Quote Link to comment Share on other sites More sharing options...
sheefreak Posted August 4, 2009 Report Share Posted August 4, 2009 Do you have any drill bits small enough to fit in the power jet? You can then measure w/a mic. I don't know what range of jet sizes a powerjet can make up for, but it is a pretty good amount. You should be able to get pretty close measuring the PJ. Obviously you will not flow anymore than the barb for the PJ that the fuel line connects to so you might want to measure that as well to make sure it isn't smaller than the tube. It shouldn't be though.... Quote Link to comment Share on other sites More sharing options...
blanco25 Posted August 4, 2009 Report Share Posted August 4, 2009 (edited) sorry to butt in your thread. but dont see to many pj threads. is it possible to run gas jets on the carbs with a power jet for alky. or does every setup need it main drilled? sorry joe Edited August 4, 2009 by blanco25 Quote Link to comment Share on other sites More sharing options...
shanYE west Posted August 4, 2009 Report Share Posted August 4, 2009 you can use a power jet with gas.. but.. usually the main jet is suffiecent in supplying enough fuel that a power jet isn't required. But.. the dump tubes have been drilled bigger in alky carbs.. So unless its a mikuni carb.. your dump tubes is set at what ever they were drilled at. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.