siezed-up Posted June 11, 2009 Report Share Posted June 11, 2009 I didn't want to take the time to sift through a hundred post to get my answer. Didn't there used to be a jetting calculator that would get you pretty close to your target jetting? I printed a copy of it a couple of years ago and proceeded to lose it like a jackass. O.k. on to my next question I have stock porting FMF pipes PWK 28mm carbs K&N clamp ons 2000 above sea level. If someone has an idea about my initial jetting that would be great, I think I'm at 150 mains and 48 pilot. Not running good. Thanks, Joe Quote Link to comment Share on other sites More sharing options...
black sunshine Posted June 11, 2009 Report Share Posted June 11, 2009 Someone had a post recently relating to this, some type of jetting form. IDK if it is stickied, but it can't be buried very deep. Quote Link to comment Share on other sites More sharing options...
siezed-up Posted June 12, 2009 Author Report Share Posted June 12, 2009 Thanks, I found it and didn't have to look very long Quote Link to comment Share on other sites More sharing options...
LiftdT4R Posted June 12, 2009 Report Share Posted June 12, 2009 If you run into trouble on those PWKs, call up Carb Parts Warehouse, as long as you buy stuff from them they should be able to help you out with the jetting. Quote Link to comment Share on other sites More sharing options...
siezed-up Posted June 13, 2009 Author Report Share Posted June 13, 2009 I will check them out ,thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.