Search the Community
Showing results for tags 'repair'.
Found 5 results
-
So I got a 06 banshee. It was stored for 10 years, a month or two ago i decided to work on it, so i changed every fluid, i cleaned it, euro coolant, cleaned the carbs ( both were clogged), it was working pretty well, until one day i went for a ride, everything well until it started to pop from one exhaust, then i discovered the left sparkplug wasnt working, so i bought 2 B6's sparkplugs (it had B8's) today i tried it and it didnt start, so we decided yo clean the carbs again but it doesnt start. Can somebody help me? Its got a rebuilt gearbox too
-
Hi Guys, A while ago I noticed a noise coming from the engine at mid RPMs and after a while I realized that it was coming from the kick starter as it was shaking a lot. i rebuilt the kick starter where it basically needed an O ring besides cleaning and lubricating and here is a link to a detailed video on how to do this. I hope this is useful to you. enjoy. https://www.youtube.com/watch?v=n96ex73S3u4&t=19s
-
So yesterday I was riding, not too hard or anything and the banshee died. No weird noises or anything, it just bogged down when I got into some sand. I kicked it a few times to start it back up and then it locked. I got it back home and drained the oil then took off the right side case to check if anything was stuck in there. Everything looked fine from what I could tell so I just sprayed some WD-40 on the gears and they started being able to turn. I put the case back on to test and then it locked up again after it was able to turn one time. What could this be?
-
Hi all I am unable to find this part in my manual or online in parts diagrams. it's under the counter sprocket ( see photo ) and made out of white plastic. Mine has got a couple of cracks in it and leaks trans oil needs to be replaced and hoping someone can tell Me what it is and where I might get one. Thanks
-
So I know this ride isn't a sports car, but I have extreme tire wobble in front left tire that makes absolutely no sense..... Alignment is good, measured it, rim is not bent, replaced both wheel bearings, replaced both rods and rod ends, a arms and bushings aren't worn, pulled tire off rim and had no fix a flat in it...... next question and I hope its not it...... Could it be my frame is bent??? Dont remember smacking anything that hard, I am completely stumped.... What's the best tip for checking if a frame is bent..... Never had this problem... Thanks you all!!! Btw new here to the community!!! Just want to say hi and look forward and speaking to you all!!!!
.thumb.jpg.6e87675a1571136849af78fb04aeea8a.jpg)
