locogato11283

If you ran a 34” axle with 3/6 wheels, you could get 46” outside to outside.

Fuck. That. Fucking park rangers will be on full dick face mode.

A lot.. Until you smash a tree or land fucked up off a big ass jump.

FYI, the two bare aluminum axles I had from JJ&A galled bad.. Switched over to anodized axles and haven't had an issue since.

LOL

If I was going to dune it, I would run a Fireball or Stellar. My duner has a Stellar.

For a rider bike, I'd go +4.

Yes to both.. But the KOTR class was on my 24DM with LEDs. My play bike with the 4mm motor and Snipers made it into the top 6 though. I beat a lot of chassis bikes out with it and I'm sure my motor was a lot smaller than most.

Snipers will likely make more power and way more off bottom than Shearers.

How so?

MFer looks tweaked to the right to me.

There’s no chart for anything. Every motor is different. Start high and work down to avoid a big problem.

I'd rather see him play it safe.. Will 280 be too rich? Probably. If it's 20 degrees and he takes it out with a 220 and does some long ass pulls with it, I bet it won't live. I'd rather see him start high and work his way back down than blow the thing up first time out. I've never blown anything up having too much fuel.. Not enough fuel is a different story.

Post a picture of the rod from the backside so we can see.

Why do you think it's bent?

Let him him burn it down then... Mathematically, that's what's bound to happen.

I agree.. Sounds like crank seal.. While you're on that side, you might as well inspect everything. It will have to come all the way apart for the crank seal anyway.

You're confused.. Stock jets go 200, 210, 220, 230.....

I would start with 280 or 290.. Remember, it's cold as fuck.. Don't burn it down.

I sent him a message on FB. I am going to try to help get this resolved.

LSR hubs FTW!

Let me see what I can do.

I have like 6 harnesses from Cory Kennedy. They’re so much nicer than the junk cut harnesses. I’d go that route, if there’s a choice.

The wobbling will cause wear. Replace bushing, washers and clip. It’ll be good then.

Narrower. Further out front. 26” drag axle.