fixitrod

I built a steel jig for doing them.

Late Prefered.

If it's a wiseco they are pink in the center. That's how you know when to stroke her.

buy your ink on ebay. It's dirt cheap.

I'm looking for a free or cheap axle carrier. The inside can be wasted. I just need the mounting taps that go to the swingarm to be in the right place. Thanks a lot !!!! Rodney

I think you are doing a fine job. Keep up the good work. Your best bet on your flyers is to also include " how easy it is to install" and maybe a "Dicount" on extra filters if Purchased with the unit.. hell, or even a free filter if purchased by the end of August.

Holyman is correct. We have went through this before and Holyman got a diagrahm from the original rz350. Just watch the bottle. It goes up and down. The stabilizer can be mounted to the frame next to the pipes.

It's not to tough. It's the easiest if you pull the front plastics and tank. Drain the coolant. Pull the hoses and take the head off. Put the new head on by following the instructions that come with the new head. You'll need a torque wrench, some screw drivers and some metric sockets. I do have a question though. How does a 16yr old afford to put a head on a banshee. I was saving for a car, insurance and paying for gas, girlfriend, and oh.. a kid.. lol.

Here's the info http://sandbros.net/forums/viewtopic.php?p=1928#1928

Took the words out of my mouth. With a 4mm crank in there It's gonna be anywhere from 33 to 38's depending on application.

Make sure when you log in you mark remember me. Also, you may need to default your browser. In internet explorer at the top go to tools > internet options> go to advanced folder > click restore defaults at the bottom> apply and ok. While your in there you might as well clear your temp internet files and history if you choose. I'd clear out the cookies too. Same as above just when you first get into the general folder you will see the options. If all that doesn't work you can default your security settings under the security folder.

Seems you have confused a lot of people 1bad

With bigger carbs you'll need some 34mm boots to go to the airbox. Then, You'll have to move the airbox back a little.

I thought you were talking about these when you said polished grills.

Not gonna swing this one. Roostfest 2006 is set for June next yr. I'm hoping just to make that one.

Put up some pics of the system and some specs. Maybe scan a brochure and post it so people know what you have.

20lb for the head bolts. I don't know about the reed cages. I've just made them good and tight in the past.

click here http://kuoi.asui.uidaho.edu/~john/tips.html

If just one plug is white and the other is not it could be an air leak. Checks the carb boots by spraying ether or something around them. If the idle chages it's the boots suckin air. Could be a crank seal also leaking. Another thing to check is that the choke tube is between them and the right slide is in the right carb and vise versa. If you look at the slide it has a section cut off the bottom. That angled cut should be facing the airbox. If not the slides are in the wrong carbs. Also spray the ether on the carb tops etc...

Looks like a good deal.

Hey, I seen that 72oz state on king of the hill. Bobby ate the whole thing

I have to agree with that. I rode jkjk's and wow.

Here's is a pic. It's a plastic spacer that goes in there. http://216.37.204.202/yamaha_oem/YamahaATV...e=13&A=115&B=10

I'm guessing the kickstarter got pushed by either your foot or the water. The plastic in the bottom may be the plastic from the kickstarter assembly itself.

Pics of everything will help it sale easier.