BANSHEEBEEFM2M

K&n or K&n style lmk what u got

I don't even know what mechanical injection is and I've never seen it done around here

Lol it was on gas in that pic. At first I was running a 41mm for 20% nitro 80 alky now I'm gonna be running 50/50 with a 44mm carb

Do I need to put a fuel pump on the shee?

this is her now

Just like any alky bike. Unless u run a fuel pump then u just tap the jug by the intake. Pingel/hose/pump to other hose/and hose from pump to the tap. Other hose goes straight to the carb

And will 8mm Reed spacers make these big bitches clear the clutch arm

Well I'm getting the 38tm's. W/pjs. They were also setup for a stock stroke bike at sea level, mine is also stock stroke and pismo is sea level. . Will the jetting be close?

stilll have carbs?

my 4 stroke is on nitro

ok im getting ready to run alky or look into it, looking at sum mikuni 38tms w/pjs or 39 pwks, bike is a 370lr drag ported, blaster pistons, 17cc domes, already have a timing plate, a pingel, etc. have 17 cc domes and copmpression is at 175 lbs on each side, i will be using castor 927 premix, ridin at sea leel.. do i need more compression? how much do i or can i advance the timing?

They have power jets? What motor are they set up for?

No cables or filters?

Pm me pics. U have throttle cable?

Slides?

Who set them up? U have tops and slides?

If u wanna sell Em back to me let me know

I know lol

Wanna trade me for my inframes?

How much in cash? Who set them up? Do u have the tops and slides for them?

Lmk what u got need a set preferably gas will take alcohol if they've been set up the RIGHT WAY

33mm mikunis. On gas. Will be a full out drag port but it's a stock stroke stock cylinder motor 38s would be too big I think

Thank you. K&t still around? I didn't even know.

California , but I don't have a problem shipping

Have 33mm mikunis, I'd like to have them bored. Who does it? How much? Will I gain some good top end? Will I have to rejet?