Slt250r222

Al Sent from my iPhone using Tapatalk

Well it turns out we had the speed wrong. Now it's cutting better but now I need to order more end mills lol. It's all a learning experience Sent from my iPhone using Tapatalk

The carbide bits definitely don't last. Would a cobalt end mill be much better? Sent from my iPhone using Tapatalk

Bump Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

We wish we had a rotary table this would go a lot faster. We already broke one bit on the first gear. Were still getting the hang of it but it's goin pretty we'll today Sent from my iPhone using Tapatalk

The rpm of the bit is around 1100 And we were feeding it manually very very slowly. The carbide bits will be here today but he doesn't have time tonight to try em. He did put a new cooling set up on over the weekend so it should go well this time around.Thanks everyone for the knowledge and in put. I'll keep everyone updated Sent from my iPhone using Tapatalk

It's a buddy's mill I ordered carbide end mills for it. They should be here tomorrow. The mills he had barely put a scratch in the gear. We tried a few different bits. I was told to run the mill at around 1100rpm Sent from my iPhone using Tapatalk

Sold Sent from my iPhone using Tapatalk

They are stock length. Never actually took em out for a ride. I went with a different set up Sent from my iPhone using Tapatalk

Double rates set up for 180-200lb rider $225 shipped Sent from my iPhone using Tapatalk

Thanks I'll see if I can find these bits local Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Ok so I brought the gears to my buddy's house. Well the gears are a lot harder than we thought. None of the cutting bits he had would cut. Has anyone used this same method of cutting? If so what bits do you use Sent from my iPhone using Tapatalk

I sit pretty far forward on the seat so the shifter is pretty low but I've been riding it like that since I had my first banshee in 2001 lol Sent from my iPhone using Tapatalk