domlav

bump 3 months later i'm still looking for a fender set in montreal area.

Hi, i'm Looking for a used complete plastics set in Montreal area. cut front fenders ok. no cracks. please PM me with pictures and price. i can drive 100 km around montreal to get them. thanks!

Hi, i need a right side spindle knuckle. Please PM me with your price shipped to CANADA J6N 2G8. thanks!

Hi, i'm looking for a clean, no pitting, stock head and a stator cover with no crack, no missing part. you must ship to canada J6N 2G8. i was thinking to pay around 75$ shipped for both parts... pm me with what you have to offer. thanks!

Hi, i'm looking for a square stator plug (2000 banshee) with a few inches of wire attached to it if possible. The stator i have was probably a late model converted to old model and the guy cut the wires a few inches from the plug. please PM me your price shipped to canada. thanks!

clutch cover purchased, will probably contact you soon n2otoofast4u. thanks guys!

Hi, i'm looking for a stock clutch cover with water pump cover (and screws if possible), also i need a stock flywheel with good threads. please come back with your price shipped to canada. thanks guys!

Im looking for a good usable condition stock head with studs. PM me with your price shipped to canada please. thanks!

anyone has finaly found the CLYMER MANUAL pdf version since this post??

Hi, i would like to buy your cylinders.

This is the kit i'm talking about: http://www.ebay.ca/itm/Athena-392cc-68mm-Big-Bore-Cylinder-Kit-Yamaha-Banshee-YFZ-350-YFZ350-87-06-/390516921194?pt=Motors_ATV_Parts_Accessories&hash=item5aec9f536a&vxp=mtr&_uhb=1#ht_5043wt_1037 sells for 690$

Hi, I would like to know what do you guys think about the Athena 392cc cylinders kit. Many people seem to say they're no good. anybody tried them? what's wrong with them?? please note that my question is more about quality than performance, i mean i don't care if its not the most HP per $, i'm just looking for fair quality at good price. Bike usage = trail i plan to use the stock crank with stock carbs. Thanks for your advices.

okay i've got something new, let's just see if i figure it out right. i ran it with air box lid revoved and the hesitation has completely disapered. so i was running rich on my needles, right? now it had much more power like this and i don't feel like putting the lid back . do some guys run like this? i guess it involves more frequent air filter cleaning but otherwise is there any problem? thanks guys!

ok i'll come back with the pilot jets size, thanks! now with 105/110 psi near sea level, should i re-ring right now or what? what do you guys think?

yes stock head, stock engine... the clip is on the 4th slot from the top, 2nd from the needle end.