jayhawkatv

Pm you

Bump

Ttt

Hubs sold

Stock

Drag ported 4 mil stock cylinders by f.a.st. 66 bore, could use new rings. Just got s fresh hone today.Comes with pistons, and set of domes. Cylinders have been 4.2's and consistent low 4.3 on a stock frame bike with 200 lb rider, no bar, no strut. $550 cylinders were on the "joker" bike at last years hq ride. stock 02 plactics with chrome grill, uncut except around pipe area for cpi's. $200- front only stock black seat looks brand new $120 34 mm mikuni round slide carbs. Never ran, got in A box full of parts.$125 probably could use a rebuild imo. rear hubs $25- sold On/off switch $30 20x11x9 turf tamers on itp rims good tread- $150 3167065788 text or call anytime. Will get pics up after work.

Ttt

Still looking...

^^^^ bike will be at hq ride

How much troy? Pic?

Blue lable rims wanted, would prefer black and drag cut but its not a must.

I bought a swingarm from him earlier in the yr because he said it would be at my house 3 weeks before it actually did. I placed my order and said he would have it out in a week since I got it powdercoated. I called 2 the following week and he said he had been busy and he would get it done. The NEXT wk I called and he told me he hadnt even started on it. I was like wtf can I just get a refund then? He word for word told me he didnt give refunds.You gotta be shitting me. I dont put ppl on blast usually if I dont have the best experience with them, but he fuckin pissed me off. I will never buy anythimg from them ever again. 2 buddies that have 250rs are pissed at the shit they got and their customer service as well.

Sundog trails in OK need this

Lmk what ya got text pics to 3167065788 Sent from my DROID RAZR using Tapatalk

Wtb 40-41 mm alky carbs

Well depending what cheap is. I really wanted 21 inch or 19

Pic?

I need a drag harness shortened up quite a bit. Cdi mounts under the tank. I need some nice black drag cut front rims, I need smooth buff tires. 3167065788, text is easier and faster

Yes alky

I have some 4 mil stock cylinders by f.a.s .t. ran a 4.2 no bar, no strut w/200 lb rider. Need honed but I will do that if you buy, comes with 2 set of domes, and pistons, ill throw in a topend base gasket. $550. thats what it cost me for porting.

In need of a good flywheel, no junk. 3167065788

Bump

I wanna buy used, much cheaper and I wont have to wait.

Wtb a dual arm hillshooter/drag chassis. I found one to buy but weighing all my options first.text pics to 3167065788

Can you send pics of the frame and swinger to 3167065788.thanks