Burke
-
Posts
1,612 -
Joined
-
Last visited
-
Days Won
10
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by Burke
-
Why am I the only @bansheehq poster?
Burke replied to ledofthezep's topic in General Banshee Discussion
2 things... 1) What the fuck is Twitter? 2) Fuck off Pissgrips!! -
-
I'd do a leak down and compression test in case you may have fucked up a seal with the pressure washer, and then start pulling electrical connections apart and drying them out and filling them with dielectric grease
-
off centered bars with new steering stem?
Burke replied to sheerules's topic in Banshee Repairs and Mods
Out of adjustments on the tie rods? -
all 4 titles have different names and addresses on them, don't they?
-
22x11x8 16 staggered rippers
-
maybe even try a little starting fluid and drag it behind a truck too... that will ruin it in no time
-
just keep trying to start it without doing any of the things that were suggested... you'll either get it to run or completely destroy it trying
-
The only idea dumber than a streetbike swap, is to leave that front end on there.
-
here's what I would do... box up all the parts you have and send them to Redline... then have Phelps send the virgin bore cylinders he polished to Redline. Pay Phelps, Pay Cameron, and wait for a badass motor to show back up at your doorstep
-
if you're considering Niche cylinders... why wouldn't you buy the polished stockers from Phelps?
-
area code comes back to Joisey... so I would assume he wants a big motored skreet racer
-
Mattoon Machine has about the cleanest banshee on the market right now
-
Because you're an asshole
-
They are probably one of the most dependable trucks out today, but I don't like the look of them... nowhere near as bad as the new titan though
-
check bearings, bushings, axle alignment, and tire pressure/ circumference
-
rust will get as bad as you allow it... everything new is thin & cheap... everything rusts up north
-
I would just like to take this opportunity to nominate this as the dumbest thread since the Banshee rap song and also DDQ as having the gayest signature ever
-
Hahaha... fucking Tyler buying up all the internets
-
42 pilot?... what needle and clip position? 165 should be damn close?... hows the AP diaphrag, squirt strength, and duration?
-
improper jetting, air leak, or it was just old and worn out junk
-
But... if it don't say Yamaha, then it ain't one mate
-
Pics? Price? Location?
-
http://lmgtfy.com/?q=custom+atv+safety+flags
-
Help a noob choose between mikuni and keihin pls!
Burke replied to Dunatic619's topic in Jetting & Exhaust Forum
145 mains, CEL needles (middle groove), 45 pilots
