JayCLL

Bump

Bump

I have a caliper 35 to your door, it has brand new pads

100 bucks a piece than, shipped to you.

They are charging you 300 bucks for a pickup???? You can just buy a pick for like 25 bucks and installed it yourself or buy a new OEM stator for cheaper than that!

RDZ 4 mil 115 rod crank with 1 weekend of racing in it 365 shipped 12 over Wheelman swinger no link(brand new raw) 275 shipped Dyna Tek coils brand new in box 95 shipped (I have 2) Polished oil dip stick 18 shipped Master cylinders 25 shipped Stock intakes with reed cages and petals 25 shipped Stock reed cages and petals 15 shipped Set of brand new outter wear 18 shipped Master cylinder with reservor SOLD Stock cylinders no port work 65mm bore SOLD Mattoon Billet cases trenched for an 18 mil, small bearing, setup for twister/dmx SOLD 8 over Metal Tech swinger no link (brand new raw) SOLD K&N filters for 35 to 39mm carbs SOLD Rear brake caliper SOLD Front hubs SOLD Mattoon Billet clutch basket SOLD Rear caliper rebuild kit SOLD Stock cylinders no port work, 1 cylinder has a fresh bore and the other needs a bore. Fresh bore is 64.75 SOLD Clear Hood SOLD Hinson Billet 8 plate inner and outter 210 shipped [/url]

PM sent

Does your flywheel rattle when you shake it?

Check the pickup on your stator, I've seen them hit the flywheel and break.

Lol ^^^^ I pull a line off my carb and drain my alky out of my fuel tank, pour 93 oct/ benol mix (same as your alky) 20:1, 28:1, 32:1 etc.... Run it until it runs like crap basically, 2 minutes on average, Than I pull my carbs off and dump the purge gas out of the bowls. 5 minutes with everything on average

I'm pretty sure the track will still be up and running

$ sent.. thanks

Thumb throttle still for sale? If so I'll take it

Also are they setup for 5/8 or banshee taper spindles?

What size are the tires?

1 rear caliper sold

Ttt

Ttt

Milan dragstrip, livernois motor sports, I know theres a place on the east side by you but I can't think of the name...

Cases sold

Bump

Make some offers

What cylinders are you wanting to out these pipes on? And what is the flange size on them?

A bunch of us are going to the track Friday.