Starwriter
-
Posts
2,475 -
Joined
-
Last visited
-
Days Won
11
Content Type
Profiles
Forums
Events
Gallery
Store
Status Replies posted by Starwriter
-
I have stock carbs K &N PODS BORD TO 65.25 PISTIONS FMF FAT . I WANT TO GET V FOR REEDS AND ADD 4T TIMING .WHAT STAGE JETS SHOULD I GET
-
Stage eleventy three. Eleventy two is for stock pipes and eleventy four is for Noss.
-
-
I have an 2006 SE Banshee, it was supposed to be stock, but it has a strocker kit, how do i find out what piston are need for this engine, it's been bored 1 mil over, and the shop doing the rebuild ordered stock piston, but when they installed the pistons they stick out of the cylinders pass the top ring.
-
Get you motor out of whatever lame ass shop it's in and let someone that knows Banshees build it.
-
-
i have a problem with my banshee my tie-rods are hitting my frame and it locks up the steering to only turn one given way unless you force it to move. what could be the problem?
-
Yep, bent forward, and edges smooshed. Needs to be bent back, edges built back up and a gusset added.
-
-
Why does American KFC have such huge pieces and every other country has small ones?
-
Because America has more fat people.
-
-
The toilet paper roll must feed over the top, never under, it's that important!
-
Unless you have cats. Cats can't unroll it if it feeds under.
-
-
4 Sale 2002 Bored out to a 471 with Wiseco forged pistons and a 4Mil crank, new racing reeds and FMF racing exhaust, Brand new clutch and much more. Runs on a mix of 110 octaine and 2-stroke racing oil. New Motor Less then 3 Hours on it. All motor work has been done professionally by a Yamaha master mechanic. Has +2" extended A-Arms ASV Clutch and Brake Levers, Brand new tires on the back. I also have a set of rear sand tires and rims that will go with it..
-
If it'll do over 100MPH, I'm interested.
-
-
I have a 2000 banshee that was just recently rebuilt because the piston seized on the right side. after the rebuild it was running good but I noticed when I filled the radiator fluid and started it, it was overflowing right away.. Soo I got a new pressure cap and it still over flowed when it was started. What could it be ?? Thanks
-
Leaking head gasket. You should have done a leakdown test after the rebuild.
-
-
Have an 03 Banshee with vibration in front end in 5th gear in dirt & pavement. Have adjusted toe in, tire pressure/s, checked all nuts/bolts for correct torque with only a little improvement. It came with aftermarket A-rms and only identifying marks/logos is a star with a break in one point on right front one. Any one recognize logo please or any suggestions.
-
Sounds like water in the tire. Try different front tires.
-
-
striped screw in the clutch case cover side.. ugh
-
Drill the head away with a 1/4" bit till the head pops off, then slide the cover off and scew the bolt out.
-
-
What Is the best smelling oil that mixes with the gas? And What Brand?
