Phelps
-
Posts
3,327 -
Joined
-
Last visited
-
Days Won
8
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by Phelps
-
Not very long. The plenum mat insulation works decent on mild bikes. Best just to order the 15 dollar package of real packing.
-
no kick start no idle when pushed runs awesome... why?
Phelps replied to Dubol22's topic in Technical Info
low compression -
you don't want it at the bottom. 2mm off the bottom. if you are warming the bike up, swapping plugs, pulling a 1-6 wot and killing it the plug should be just a tad lighter than the 170 main pic. and the ring should be about the same distance off the bottom. if the 175 pic was a single pass those plugs will be fouled within 20-30 minutes.
-
shopping cart wings and fart cans don't make sunfires fast , but ppl still put them on...
-
ok i will pm you when i get one done. should have one ready by the first of next week.
-
i have plenty of cores back now. you needing to buy one outright, or?
-
Prides... tough name for feelings.
-
150-155 i would suspect is where you will need to be. at 800ft elevation most are around 145
-
if that's a single pass i'd say it's too rich. rough bog on topend?
-
new member ...my first banshee...need help
Phelps replied to warshee's topic in Banshee Repairs and Mods
was probably never jetted for the K&N's. huge difference between stock and K&N's. about 3-4 jet sizes lol -
Lmao
-
How old? About how much time on it? Was it in a Gas, or alky motor?
-
most guys that run water have their bikes down a lot. they use distilled water. tap water will eat at the aluminum over time, rust and steel parts etc.
-
first time banshee owner questions.
Phelps replied to Mrtaterman's topic in Banshee Repairs and Mods
wot bog (clean bog) would suggest lean. i would start with 220's with the aftermarket filters. on the chain depending on sprocket setup you may have to go with a half link. you may try new rollers and see if that helps. i just use a chain tensioner to solve the typical chain issues. -
How does one bore a cub cylinder?
-
no whining, yet this entire post screams whine....
-
You didn't leakdown test it or jet it properly and leaned that cylinder out.
-
Nope they will be at their new owners monday.
-
lmao db
-
Depends on how you set them up. They can be plush, or no movement at all. All depends on pressure settings
-
Marvin shaws are going to be your best bet. Light,many different height setups, pressure setups and look clean.
-
i run rig alky with klotz with no issue. just make sure it's in a sealed poly drum and don't smell like water. only difference is how much they filter it.
-
just buy marvin shaws if you're not looking for travel. r1 shocks are gonna look ignorant on the front.
-
3-4 up for pods 3-4 up for pipes 3-4 down for reeds.
-
Sold.
