Jump to content

BANSHEE HP

HQ Site Sponsor!
  • Posts

    1,807
  • Joined

  • Last visited

  • Days Won

    10

Everything posted by BANSHEE HP

  1. I'd steer clear of this seller. Your looking at a listing for new cylinders ported but the pics are of used cylinders ported and a new niche cylinders in the other pics.
  2. keep that broken piece and have someone weld it back on there
  3. Hot Rods 4mm 115mm rod crank. Low hours, true welded, tight bearings. $300+ shipping for $40 more ill include 2 new wristpin bearings and crank seals.
  4. The cases are sealed with a labyrinth seal between the center crank bearings.
  5. tell us all how those bearings dont hold up and blow apart.
  6. nice looking stuff. whats the ticket on polishing a set of stockers?
  7. 400ish is a little more than I would charge but it's not far off. 100 to bore 200 for 66mm pistons 40 for gaskets 20 for wrist pin bearings
  8. Still looks rounded over and your vice grips are over the notch
  9. You didn't file it enough then. The notch needs a sharp edge all the way around
  10. You can pull the spring to one side, hold it with the needle nose and then file. Whatever is easier
  11. There are 2 notches. When you fully extend the plunger you see them. Closer one to the knob is half choke, the further one is full choke
  12. Do not buy a new one... pull the plunger, hold it with needle nose pliers, take a small file and file the notch.
  13. Where do I sign up for the banshee nation?
×
×
  • Create New...