Boston

cpi? um i run all mine at 40-1 with klotz. never had a problem with that ratio

coolhead 125 shipped

maybe just wraping it? lol idk..

you get my pm???

lil jockey buy the thumb throttle!!

have you seen the stainless kit on ebay?

if that guy takes the throttle assembly I will take the stem. pm sent.

ttt

what might you be doing with the drag frame? i have a stock frame with a title.

hey joe kinda off topic... but do you happen to have a set of case halfs and cylinders over to k&ts? anyways free bump.

maybe plugged or adding to much oil?

check your tester as well. I just built one over the weekend and tested it out today and i had a slight leak at the gauge. It was a very slight leak but Ill get it sealed up for next time.

fix the leak. get a spray bottle and put warm soapy water in it. Spray all around the intakes, exhaust, base and top end gaskets. If nothing then take your stator off and spray around your crank seal. It should hold 6 for 6 but losing 1 pound would be ok.

tell ya what.. send me pics to dunes_for_life@yahoo.com and ill post them for ya.

might want to post a picture of it. there is usually a couple caps/spacers that go on each side. post pics and youll get the answer you need.

lol.. dont run them. only run proven brands that you know are good. ya they are expensive, but thats why they are.

ttt

hey thanks for the pics. im looking for the 2 piece style. thanks anyways and good luck.

pics to dunes_for_life@yahoo.com

pics of billet basket and intakes to dunes_for_life@yahoo.com

Could you guys send me pics to dunes_for_life@yahoo.com?

spindles for banshee bearings intakes for 40mm carbs id prefer the individual intakes vf3's for cub cyclinders lightweight a arms id prefer finish not be in good condition because ill be powder coating them fox floats 22x11x8 sls 12-14 extremes or haulers billet baskets & straight cuts dunable override think thats all i need right now and i have alot of stock and a few aftermarket stuff to swap and trade so let me know what you got please.

hopefully not because they didnt jet the carbs after the pipes where put on.

do you have tors? what jets are in it, elevation, and temp?