armando

ok i tuned it and changed the air filter. runs perfict. thanx for the help, i needed it

no i had the choke pulled for about 5 minutes and pushed it back in than it died

it runnss!!!! thank u, starts 1st kick with the choke pulled but when i push the choke back in, it dies a couple seconds later

thanx guys. im going to try every thing and hopefully i runs, its been sitting for a month and its been killing me i couldnt go ride in the snow.

so just switch the bowls? thats it?

what do you mean by clean the needles and seats, are you talking about slide in the carb? this is my 1st banshee and this is the 1st time i needed to do something to it besides change tranny oil.

ok i just cleaned out both carbs completely and but everything together again, it wouldnt start but i did what my friend told me to do, stand the quad up and flood the carbs, and put the quad back on all 4 wheels again, i did that and it started 1st kick but died in about 45 seconds. i dont know whats wrong with it

haha i just rebuilt it and i was looking at it and the crossover tube was loss so i pushed the tube in further, i took the plugs outs and put a little bit of mixed gas in each clynder and it fired right up but it died a sec later, i guess its not getting gas, i had the carbs rebuilt before the topend. any thoughts?

yea the crossover tube is connected and i didnt touch the fly wheel, this was the 1st time the quad has ever been apart

yea well it started needing 3-4 kicks to start so i thought id change it right away and yea its getting fuel and im pretty sure its getting spark.

okay hey i just replaced the topend on my banshee today. i changed the topend early so i could keep it on stock bore, i changed the pistons, gaskets, etc and put it back together easily with no problems. but when i went to kick it over, it wont start, didnt have any problems before and the quad has alot of compression with the new topend. just wont start. help?