kawa110

Driveline for clutch. Install billet basket, and pancake bearing pusher. Modify shift star. Sent from my iPhone using Tapatalk

Too much of a leak for me. Make a mess of bike when riding. 1. Cheapest(may not work) JB weld/epoxy 2. Attempt to weld on bike(cases get to hot will damage oil seal at countershaft sprocket and shift shaft) 3. Tear down and have welded 4. Find good used cases, swap everything over, install new crank bearings, seals, trans bearings and new piston rings. Sent from my iPhone using Tapatalk

I used to be a people person, but then people ruined that. No joke Sent from my iPhone using Tapatalk

Support frame with rear wheels off ground, supports swingarm, Take the upper shock bolt off and be done with it. Sent from my iPhone using Tapatalk

Yes, for 350 I’ll throw in a carrier. Sent from my iPhone using Tapatalk

Buy the IMs pegs. Those bolts are great if you want to spend 25$ on four bolts. Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

One just posted in for sale section. Sent from my iPhone using Tapatalk

[emoji106] [emoji1690] Sent from my iPhone using Tapatalk

Interested in hand guards, they just dirty or kinda bushwhacked? Sent from my iPhone using Tapatalk

[emoji106][emoji1690] Thnx Sent from my iPhone using Tapatalk

I’ll take it. Your led bulbs most likely burned out. Sent from my iPhone using Tapatalk

Are the lights wired? Bulbs any good? Sent from my iPhone using Tapatalk

My fireball arms came with tie rod end ball joints. Sent from my iPhone using Tapatalk

Why not get the ends from fireball? Sent from my iPhone using Tapatalk

Would it hurt? Or be added protection? I really don’t know, I got one for my negative arm, but haven’t gotten to that part of build yet. Sent from my iPhone using Tapatalk

I’m not sure..... I just know it ensures consistent tension throughout the swing arm travel. Sent from my iPhone using Tapatalk

Chariot chain tensioner. I see a case saver same as a skid plate. Added protection. Yes, ensure you maintain your chain. I hate when the chain rattling can be heard over the engine on “any” bike. Makes me cringe. I too am curious on what chain everyone here recommends.... Sent from my iPhone using Tapatalk

The plastic will “absorb” the “impact” in the event of snapped chain. If you ride the bike enough you will eventually want the roundhouse style swing arm... Sent from my iPhone using Tapatalk

^^^ Need bar clamp Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Looks like the locking tab washer wasn’t installed and the eccentric screw nut backed off. Sent from my iPhone using Tapatalk

Bit if it was yours it is ready to reunite with you. Sent from my iPhone using Tapatalk

Naw, got it from a local guy we all know Sent from my iPhone using Tapatalk