Coupelx

Can you make that pic smaller for us. Thanks.

http://lmgtfy.com/?q=Mikuni+emulsion+tube

That wouldnt suprise me. They are pretty cheap looking overall.

Coasting at a decent rate speed with the clutch pulled in (maybe oil level plays a roll here?). The pancake bearing is a great idea but the simplest thing to do is dont pull the clutch in and coast for long distances. I dont run one (pancake bearing). Just never got around to it i guess and the most i coast with the clutch pulled in is down a hill into an idiot hole or whatever at the dunes which is a fairly slow roll

An overly rich mid range can mask a lean top end to an extent. Slit your wrists and go the fuck away, seriously. This.

Apparently if you drill the tiny ass fuel inlets out they work fine. other than it being a generally cheap piece of shit that was the only real issue with them?

Tru Dat.

I bet you will end up around a 140-145 main and a 40 pilot. edit: also try a jjh needle. made a world of difference on mine vs the stock (n68a?) needles.

fucking hate packing peanuts. i usually get the shop vac out and vacuum them bitches right out of the box.

That is how my chrome LSR a arms arrived from a seller on here. one of the tie rods never made it. shit hanging out of the box, arms beating the shit out of each other.

I did mine in a standard oven. I want to say the high temp stuff from powderbythepound i used bakes around 400-450. Be interesting to see how the clear holds up to the heat. I did hightemp clear on the intake on the moostang i had and it slowly turned yellow.

Mine have been coated for a couple years. held up great except for the first few inches off the cylinders. its slowly burning off there. the rest of the pipe is still decent even where your legs rub while riding.

night and day difference from a worn the fuck out stock rear? Fuck I hope so. night and day difference from a rebuilt stock rear shock? Possibly depending on your experience level.

You're Welcome.

silicone on base gaskets is a no no.