Jump to content

sheerider11

HQ Premium Member
 View Profile  See their activity

  • Posts

    12,928

  • Joined

  • Last visited

  • Days Won

    107

 Content Type 

Everything posted by sheerider11

  1. sheerider11
    Pm blowit
  2. sheerider11
    I've seen them used. Not recommended. That thing spins really fast and now the balance is off, the fibers have a spot to flex where there is no contact. I don't advise it
  3. sheerider11
    Damn now I need to check mine
  4. sheerider11
    Post pics when your done!! I just told some one to do the exact same thing
  5. sheerider11
    Last day
  6. sheerider11
    I hope this gets to him back in 09
  7. sheerider11
    A doucheing in the carbs isn't going to work. Pull the jets and really clean them. Why did you move the needle?? Untwist the wires.
  8. sheerider11
    I just might have to figure out this shift problem tonight and tomorrow.
  9. sheerider11
    Part it and make more. I will help you out and buy a few small parts.
  10. sheerider11
    Don't fuck up
  11. sheerider11
    Like I said in the other thread, take a look at the bottom end walk through. Its easy. Replace all the seals at the same time.
  12. sheerider11
    I want a shot at the cub too
  13. sheerider11
    Yup. Take a look at the bottom end walk through.
  14. sheerider11
    Take it to a shop. Ask them to check it. If it's out of spec you need a bore. A good shop will hook you up
  15. sheerider11
    Un plug tors box under tank, unplug throttle switch
  16. sheerider11
    Crank seal
  17. sheerider11
    Hahaha, all the time. We just all have to go to the bar and get tore up and just forget everything
  18. sheerider11
    Did you ride that cut trans?
  19. sheerider11
    why wouldn't I just go through pc and get brand new ones for 200??'
  20. sheerider11
    Thus is well worth every penny!!! Do 50 dollar runs and make your money back in no time! What is wrong with people??
  21. sheerider11
    You got the pin lined up? Did you try to tap it with a rubber mallet to see if you can get a little more room out of it?
  22. sheerider11
    Well you came to the right place. Now I'm confused by what you said this guy did the rebuilding or east coast?
  23. sheerider11
    Are the steels discolored? And calipers are garbage. Use a micrometer. Run out is hard to check. Luckily the hub and pressure plate are cheap.
  24. sheerider11
    How's the bearing?
  25. sheerider11
    Did you replace the seal? And wait more then 20 minutes for a response. It's late and past a lot of people's bed times. I just sneak back to the computer

BHQ Quick Links

×
×
  • Create New...