papa_smurf49319

love my fullbores!

Hope is all and well Jeff! Still rocking 2 of your seat covers!

He ported both me and my wifes cylinders a few years back. We waited a while for them, but like mentioned above they run awesome, look awesome, and I couldn't be happier! Took down plenty of other big name motors with my little 12 port 4 mill on 110.

That was me Brandon lol, so far so good, havnt gotten much ride time on it since then. Shees sat for a few years but had them out at the dunes a couple weekends back and couldn't be happier. So far so good.

Jerry came through for me! Boss racings mailbox is full for his phone number.

That's what im thinking. Hopefully I can have Jerry overnight to me. Have Thursday scheduled to fuck with the banshees, and would like to get them all ready to go. But if I have to use some silicone to get by until they come in hopefully by sunday when we go, ill make do. Hopefully I don't find any suprises when I pop both cool heads off to install different domes after sitting two years(in a garage).

Jim does some awesome work, he ported both mine and the wifes bike. He is very informative and knows his setups well. Ive ran against many other site sponsors stock jugs and never had a problem beating them with my stock swinger ( need a longer arm bad). Jim is however a piece of shit to get ahold of, doesn't answer his phone, and getting ahold of him is like hitting the lottery. There was always an excuse or some sort of bullshit that was going on when he finally got ahold of you! His port work is like art and his motors run so sweet, if you can deal with his crap, and wait! I love my passion 12 port, but as of late if you want to talk to him forget about it. Ive spent 1000s of dollars with him, wanted some custom domes for my wifes bike, called him and he didn't even get back to me. Called dave noss right up and he helped us through it! That's some serious customer service. Best guy ive dealt with!

30 mins north of grand rapids. Id be wiling to drive a couple hours. Off all week on vacay

Appreciate the fast reply guys!!! Hoping to get away with less than a 60 dollar bill. My intake has been great so far, although I did tear it apart and three bond the shit out of it! Just want to replace these cracked boots asap, before I do my test and tune for the weekend. Mine and the wifes banshees have been sitting for two years and hoping for no other suprises. Fresh fuel and plugs, some type f tranny fluid, carb clean, and I hope ill have them running.

Sent him a message on ebay. Anybody know his number? Thanks Cody

Thanks, Ill call Jerry. He should have some you think?

Okay going to the dunes this weekend and need to have my bike ready by Friday. Working on it Thursday and after sitting two years my boss billet intake with built in crossover boots for my 35mm keihen carbs are cracked severely. I was going to silicone over for now but am afraid it might be too deep. Question is im in Michigan and need the boots by Thursday morning. I realize its last minute but I will pay the shipping to get them here, but I think there just a mikuni boot and somebody closer than inland or boss should have them. Any help is appreciated, calling boss in the a.m. Thanks guys Cody

If you decide to part, I'd be interested in swinger, axle, chain, brake line, Carrier, etc

That's what I was thinking. I see no need for the wider rim, but the offset is what I was worried about. Gonna order them today.

Place to drain water and dirt