Jump to content

jetting or carb sync issue?


Rage_kage

Recommended Posts

I have developed a problem after installing a adjustable timing plate and new throttle cable on my banshee. I put both items on at the same time so its hard to narrow down which it is. It accelerates just fine and wot it runs like a banshee but as soon as I let off for a second and try to get back in it the power isn't there unless I pull the clutch and give it a rev. I don't really know the symptoms of unsynced carbs and I haven't played with my jetting since I set it to what FMF recommends. I backed the plate from +4 to +3 and the issue didn't really resolve any. Any input is appreciated

 

Roughly 1500 ft above sea level

Stock carbs

Main: 260

Pilot:30

Stock needle

3rd clip

+3 advance timing

FMF fattys and powercore 2

No airbox lid

Plugs went from a nice tan (pre installation) to black but not sooted black

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...