Jump to content

Banshee float level setting


Recommended Posts

Can somebody tell me if this is the proper way/ place to measure on the inside edge of the carb where the bowl contacts to set / measure the Float level I found this pic after some searching but wanna confirm that its correct and 21mm is the correct spec ??

 

bansheefloatlevelsetting.jpg

Link to comment
Share on other sites

21mm without the gasket.

 

Yeah kinda figured as the gasket is a few mm itself and yes my floats were off a few mm as I wasnt sure about the spring loaded needles and compressing them or not i have got it running pretty good and the floats are at 21mm now Thanks !!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...