Jump to content

NEW INFRAMES


PassionRE

Recommended Posts

I got oof shearer right now. Would i get more from inframe snipers? Im dragging on 300ft sand.

 

 

 

 

 

heres a copy of the GAS dyno sheet 421 Cub Sniper inframe vs. Shearer OOF drag pipe

It is based on ground speed instead of RPM...its all I have on hand at the moment .Dyno operator killed the test early after peak HP....both pipes have better over-rev than what the chart would indicate

 

 

snipervsoof-1.jpg

Link to comment
Share on other sites

Post RPM on bottom of dyno runs....otherwise people are going to ask why this motor is only capable of running to 70 MPH, then falls on it's face. :shootself:

Link to comment
Share on other sites

Post RPM on bottom of dyno runs....otherwise people are going to ask why this motor is only capable of running to 70 MPH, then falls on it's face. :shootself:

Yea, I know, thats why I gave the footnote..Its all I had on hand...but the HP and Tq. speak for itself

  • Like 1
Link to comment
Share on other sites

Hey Jim is that similar to what this motor you ported for me should be?

Your torque numbers should be a little higher than this engine...peak hp should nearly the same.

Link to comment
Share on other sites

  • 10 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...