Would you call this good PORTING? Also would any of you builders let your work go out like this ?

[jay shafer]

Is this good porting?

[jay shafer]

second one

[NYUK]

what do the transfers and exhaust look like?and who did that?

[Glenyboy]

Nothing looks parrallel or smooth, did they use a hammer and chisel

[Larry's Shee]

Are those stock cyls? I don't get it, you have a grinder in your hand, it's not that hard to do it right. Even this old caveman can do it.

[sprinklerman]

Run it and see.  A "good" port job to me RUNS good,,,i don't care what it looks like. ( As long as its not a ring snagger,etc)

[jay shafer]

Dont run worth a shit....paid good money and was from well known reputable builder...I had 7mm stock cylinders from dan hull that would run all over this motor with no bar

[jay shafer]

Not stock cylinders but not cubs....but supposed to run like cubs...builder said this the best he ccould do and all porting aint pretty....supposedly made 120

[jay shafer]

Not stock cylinders but not cubs....but supposed to run like cubs...builder said this the best he ccould do and all porting aint pretty....supposedly made 120

[locogato11283]

What the fuck motor is it? I don't see any pics.

 

 

 

[okbeast]

RDZ cylinders

[camatv]

looks like rough port on a set of athena's......

 

no  they wouldn't have left my place looking like that.  UNLESS  whoever order'd them was a total cheap ass and only paid 50 bucks for the work?   just sayin.   but even then i dont think i would have done that at all. 

[theshee]

Looks like a classic dremel tool/ die grinder garage style hack job.

Who did it and what motor is that?

[rubberneck]

Hit up member apeik.  He has a great set of domes that would match this hack job well.  Hell he'd probably donate them to the cause

[jay shafer]

ok these are 7mm rdz eliminator cylinders that i paid well over a 150 for a porting and upwards of a 1000 for this.  I have played with this motor 

for too long for it not perform better than some stock cylinders that i had before.  I have seen this mans work on some cylinders before i got these 

and it dont look anything like this. His actual words were "this is the BEST he could do"....go figure....

Edited August 25, 2013 by jay shafer