Jump to content

banshee synch


RKJLOW

Recommended Posts

trying to synch my carbs up I can get it synced up with the fast tool but the slides are pulling uneven by sight.... so i adjust them with out the tool (dead nuts pulling up at the same time) the synch tool reads diffrent from each carb what's going on here? did a compression and leak down blows 120 each hole and held 6 psi for 30 min

Link to comment
Share on other sites

Lower the idle screws till there not effecting slide height, adjust cable play so each carbs pulling up at Sam time, then go to the sync tool , don't forgot to move idle screws back up before you start. Also don't forget to leave a lol free play at the thumb

Link to comment
Share on other sites

Lower the idle screws till there not effecting slide height, adjust cable play so each carbs pulling up at Sam time, then go to the sync tool , don't forgot to move idle screws back up before you start. Also don't forget to leave a lol free play at the thumb

ill give it a go i had a helluva time adjusting the slack in the cable i have so i bought a new one... are yfz450 thumb throttles different than the banshee ones or are they a plug and play? wondering if that might be adding to the mix with my cable issue 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...