Jump to content

4 mil cub setup


MacRacer1

Recommended Posts

So I'm building a 4 mil cub on alcohol with shearer inframes. It's going in a stock frame. I'm building it as a dune/drag bike. It has a +10 arm and a marvin shaw on the back, with 11 paddle extremes. What would you guys run for a swingarm and paddles? I'm thinking a +12 with 12 or 14 stags 74ro

Link to comment
Share on other sites

Thanks everyone. I think im going to start out with what i've got right now, but with my 4 mil stock cylinder it spins the tires a lot off the launch. I'll try the 11's, and some other tires and see what I like. With a +12 arm would 14 stags be too much for the motor? 

Link to comment
Share on other sites

At 150lbs if your blazing the tires off on a 10 arm you sitting to far forwards. You need to get more weight over tires.

With those tires and arm you should be able to stand that bike up no problem

Edited by m671054
Link to comment
Share on other sites

You were complaining about spinning the tires but say you can stand it up also. i suggest you figure out where to sit on the bike to get less spin but can control the front end still. More paddle will just bring the front end up easier. Youve got the right stuff you just need to figure out how to make it work.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...